extrapolation of contour data set
3 次查看(过去 30 天)
显示 更早的评论
Hello everyone!
I have made a contour from my data (both is attached), but I need have data in contour that is from 0 to 0,1.
I tried to increase the size of the matrix by giving smaller increment to the variable but even 1000x1000 matrix gave the same contour.
If you know the solution, please share. Thanks
0 个评论
采纳的回答
Bjorn Gustavsson
2022-5-6
Since the minimum value of your counttest-variable is 0.0853 or thereabouts you will never get any contour for levels lower than that. You can make contours at arbitrary levels of your choise:
contour(counttest,[0:0.001:0.1,0.2:0.1:1]) % or whatever levels you so desire in the range of the data
HTH
2 个评论
Bjorn Gustavsson
2022-5-6
You should always look at your data first. Try:
plot(counttest)
and you will see that you have a rather broad minima in your 2-D data. Any interpolation will lead to additional points inbetween the values around your interpolation-points. If you were to extrapolate outside the edges of your data the "sensible" (in the extent that can be applied to extrapolation) extrapolations would lead to increasing values - since both gradient and second derivatives are positive. Therefore your data will have a minimum at around 0.0853. If you expect to get some response at below that you will have to do something completely different.
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Contour Plots 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!