Finicky model reference in accelerator mode

3 次查看（过去 30 天）
Michael
Michael 2015-2-9
I have a Simulink model (let's call it "parent") which has a referenced model (let's call it "child"). The model "child" has one inport and one outport, both defined by the same bus object; "child" can run in normal or accelerator mode (though its outputs are meaningless when run alone). When I add "child" as a Model block (i.e. model reference) in "parent" and try to run it in Accelerator mode (both the Model block's simulation mode and the simulation mode for "parent") I get the following errors in Simulink's Diagnostic Viewer (running release 14a right now):
Error: Simulink Coder Error: Nonfinite value in structure parameter is not supported
Component: Simulink | Category: Model error
Error while bringing model references of model untitled up to date: see errors reported above for details.
Component: Simulink | Category: Model error|
I can't seem to find much on this error. However, if I switch "parent" and its Model block to run in Normal mode, then the thing runs just fine.
I am unfortunately unable to share the model, but does anyone have any ideas what might be causing this error when attempting to run in Accelerator mode? Or does anyone have a suggestion on how to debug this issue? I can get the same errors by simply updating the diagram on "parent" but can't figure out how to get any further hints as to what might be causing problems.

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Event Functions 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by