RF Blockset / Simulink: Perform a frequency sweep of a mixer model

12 次查看(过去 30 天)
Hello Matlab Team,
I am having trouble configuring an RF Blockset Simulink model. I have a system that features a filter and a mixer. I would like to put in a frequency agile signal (chirp) and see the realtime response on the Spectrum Analyzer. I've attached the model an included an image below.
Model Overview
I am sweeping a 100-200MHz@4dBm signal through the model with a Mixer with a 50MHz LO. For simplicity, I am using a unity gain s-parameter file for the 'filter' model and the CPWG is 50Ohms (when using just these two blocks I can observe signal output). When I run my full model, I would expect to to see the modulation products from the mixer and the fundamental tone from the output signal while the simulation is running.
For example, I expect to see 150MHz and 250MHz mixing products when the frequency sweeps to 200MHz. I would also expect to see in my spectrum a 50MHz LO at around -14dBm (10dB LO to IF isolation).
Instead, I see no the output which makes me believe I have a configuration parameter incorrect. I used the model_IQdemod example as a starting point and normally do modelling with the rfckt objects.
Am I misunderstanding the functionality of the RF Blockset Mixers?
Thank you

回答(0 个)

类别

Help CenterFile Exchange 中查找有关 Circuit Envelope Simulation 的更多信息

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by