When the plot function is called it generates the desired wave. However when a scope is used to observe this , constant values are rather observed. The same output is observed when the dispaly block is used - all values are generated at once even for a single step. What could I be doing wrongly here?
It also takes a long time to complete simulation when used in Simulink compared to Matlab.
See below the code.
function y = fcn()
sine1 = dsp.SineWave('Amplitude',1,'Frequency',60,'PhaseOffset',0,'SamplesPerFrame',1000,'OutputDataType','double');
y = sine1();
The idea is to later make the amplitude an argument(input) to the block so it can be varied.The application will be to make a closed loop control that uses over modulaton of SPWM..
