To analyze recorded signals of a car driving on a track, I need to identify and isolate the effective data range to perform further calculation. Below is what a typical speed signal may look like, with the x-axis being time. The data is simply stored in a ?x2 matrix with time being the first column. Since the car drives in circle, three repeated pattern can be identified visually, however, we didn't know what the pattern looked like. There are three types of unwanted signals to exclude:
- Continuous 0 or NaN at the beginning and the end (the periods between cycles are to be kept)
- The small hill before the first cycle. Sometimes it also happens at the end, but never between cycles.
- That false peak at the end caused by sensor gliches.
In the end, I only want to keep the blue line region for further processing. My current method is to first use rmoutliers to get rid of false peaks. Then to identify where the real cycles start, the code searches where the signal first reaches half of the maximum speed, and then locates the last time it went back to 0. The use of half the max speed is arbitrarily chosen, because the little hill (type 2) is usually less then that. However, sometimes it also causes a part of the pattern to be removed as well (yellow region), because it's smaller then 1/2 max speed and is followed by a 0 region. It would be most ideal, if a function can simply identify repeated pattern in a set of data, without knowing what the pattern looks like, so that I can simply extract that region. If not, any way to filter out those unwanted parts is appreciated as well.
