Hi Jeremy,
I understand you are using a Kvaser USBcan Pro 1 to communicate with a TI processor board with the help of the Vehicle Network Toolbox, and sometimes losing connection.
The ID value 4.295e9 that you are observing is very close to the maximum value for a 32-bit unsigned integer (2^32 - 1 = 4294967295). In the context of CAN communication and the Vehicle Network Toolbox in MATLAB, this value is often indicative of an error or a special condition rather than a valid CAN ID. Here are a few potential reasons why you might be seeing this value:
- Error Frame: The CAN protocol specifies that an error frame will have an ID of all dominant bits, which could be interpreted as the maximum value for an unsigned 32-bit integer. This could be an indication that there is a transmission error on the CAN bus.
- Bus Off State: If the CAN controller on your Kvaser device goes into a bus-off state due to too many errors, it might stop participating in bus activities, and this could somehow manifest as receiving the maximum integer value as the ID.
- Overrun Error: Sometimes the CAN controller's receive buffer overruns (i.e., messages arrive faster than they are being processed), this could also result in erroneous data being read, potentially including this maximum value.
You should also look for any error flags or messages from the Vehicle Network Toolbox that might indicate what the problem is. You can also check for any physical layer issues like loose connections or bad terminations. The toolbox might provide diagnostic information that can help you determine whether you're seeing error frames or other issues.
You can refer to the following page for reading more on CAN hardware:
I hope this helps!
