HYDRODYNAMIC FORCES (SIMULINK/MATLAB)

Question

Muhammad Danish 2015-2-18

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/178997-hydrodynamic-forces-simulink-matlab

编辑： Mike Hosea 2015-2-18

I want to integrate a pressure equation to get the hydrodynamic bearing forces. the way I am doing it is as follows: function [forceR,forceT]=forces(eps,epsd,dalfa,ombar)

c=0.0001; Rb=0.024; Rj=Rb-c; Lb=0.02; u=0.01;

del0=(atan(epsd/(eps*(ombar-dalfa)))); del1=del0+pi;

z0=0; z1=z0-(Lb/2); z2=z0+(Lb/2);

%Pr=(((6.*u.*c)./((c.*(1+eps.*cos(del0))).^3)).*((epsd.*cos(del0))+(eps.*(dalfa-ombar).*sin(del0))).*((z0.^2)-(0.25*(Lb^2))));

fun1 = @(del,z)((((6.*u.*c)./((c.*(1+eps.*cos(del))).^3)).*((epsd.*cos(del))+(eps.*(dalfa-ombar).*sin(del))).*((z.^2)-(0.25*(Lb^2)))).*cos(del)); fun2 = @(del,z)((((6.*u.*c)./((c.*(1+eps.*cos(del))).^3)).*((epsd.*cos(del))+(eps.*(dalfa-ombar).*sin(del))).*((z.^2)-(0.25*(Lb^2)))).*sin(del));

forceR=-integral2(fun1,del0,del1,z1,z2)*Rb; forceT=-integral2(fun2,del0,del1,z1,z2)*Rb;

end

fun1 and fun 2 are dependent on del and z and the upper and lower limits are from del0 to del1 and z1-z2.

this is an embedded function in a simulink model. (coder.extrinsic).

The program starts running then give me an error when the simulation reaches 2-3 percent.

I shall be really grateful if anyone of you could help me in this.

Regards Danish

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Mike Hosea 2015-2-18

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/178997-hydrodynamic-forces-simulink-matlab#answer_168498

编辑：Mike Hosea 2015-2-18

I don't seem to be having any difficulty integrating this problem with the parameter values that I make up. What are the values of eps, epsd, dalfa, and ombar when the simulation fails? I do note that you will need abs(eps) < 1 or else there will be a singularity where 1 + eps*cos(del) == 0. Something very close to one may also be numerically challenging.