simulink sum wrong output
3 次查看(过去 30 天)
显示 更早的评论
Hi,
I'm simulating my discrete controller but got one problem with the sum function (in red circle). The two inputs are plotted with the purple and yellow lines and the output is the blue line. At 0.3s the sum outputs a very large result about -7*10^7 even after I set the output limit to +-50. But from the inputs, the result shouldn't be that large. I tried different time steps but that didn't help. Did I set something wrong? Any advice will be appreciated.
Regards, Jiaqi
0 个评论
回答(1 个)
Abhishek GS
2015-2-24
Hi Jiaqi,
The Output Minimum and Output Maximum do not saturate or clip the output signal. Use a saturation block after the Sum block if you intend it for that purpose. The Output Min and Max values are used for Parameter range checking, Simulation range checking and Automatic scaling of fixed-point data types. Refer the below link for more information.
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Model Verification 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!