Failed:Code generation information file does not exist.
显示 更早的评论
Hello,
I am trying to build and upload some different models to TMS320F28379D in Simulink. However I get the same following error. Similar errors are asked on previous messages but there is no answer to explain them.
What is the reason of this error and how can i solve it?
回答（1 个）
Apeksha Bagrecha
2022-9-21
编辑：Stefanie Schwarz
2023-11-22
2 个投票
The message "Code generation information file does not exist" itself is expected behavior and means that the code was generated because it had not been generated prior to the build.
1 个评论
Gokhan Solak
2023-3-3
Sometimes it is ok, when it says "Action: code generated and compiled", but in this case it says "Action: failed", and the simulation will not run.
In a similar question, someone recommended removing spaces from the file path, or shortening the file path (moving the file).
类别
在 帮助中心 和 File Exchange 中查找有关 Simulink Coder 的更多信息
2022-9-15
2023-11-22
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
