How to read from serial port with matlab (timeout problem) ?

2015 3 17

2 个回答

更新时间：2018 3 5

3 次查看（30 天）

请先登录，再回答此问题。

Follow Question

请先登录，再回答此问题。

Follow Question

显示更早的评论

0 个投票

Dear all,

I want write/read to/from a serial port with matlab, to communicate with a trinamic step motor. I checked that I properly write to the port with port monitor software, but nothing comes out of the port when I attempt to read from it (I just get a timeout, even if I change the time out time to 20 sec). I've looked into the trinamic documentation, but the example they provide (a simple fread) doesn't work.

The point is I manage to read from the port with a Labview "VISA read" VI, but I can't match what this VI does with matlab... And because I'm a rookie when it comes serial port communication, I don't even know where to start...

Any suggestions ?

Thanks !

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Follow Question

回答（2 个）

Anusha B 2015-3-17

0 个投票

The cause of the issue may be similar what is mentioned in this link:

http://www.mathworks.com/matlabcentral/answers/98527-why-does-a-serial-connection-to-a-ublox-gps-device-from-matlab-timeout

One way to check this can be to see if you can read and write to serial port of any other hardware device using MATLAB.

Hope this helps.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Stéphane 2015-3-20

Thanks for your reply.

I've updated the driver but doesn't change anything.

I've seen that I may have to write all the 9 bytes at once, but I'm not sure how to do that, so far I've only managed to write one after the other...

请先登录，再进行评论。

Stéphane 2015-3-20

编辑：Stéphane 2015-3-20

0 个投票

Thanks for your reply.

I've updated the driver but doesn't change anything.

I've seen that I may have to write all the 9 bytes at once, but I'm not sure how to do that, so far I've only managed to write one after the other...

If I can be more accurate : I need to write 9 bytes at once (and read them), something like 01 00 06 02 00 00 00 00 07...

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Dp 2018-3-5

Hi were you able to write and read with Matlab? I plan on doing the same thing with the tmcm1633

请先登录，再进行评论。

请先登录，再回答此问题。

类别

在帮助中心和 File Exchange 中查找有关 Instrument Control Toolbox Supported Hardware 的更多信息

标签

2015-3-17

Dp

2018-3-5

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Translated by