Configure the simulink spectrum analyzer with custom Span (Hz)
3 次查看(过去 30 天)
显示 更早的评论
I am using the Spectrum Analyzer in Simulink. I need to see the signals in the 100kHz range with about 20kHz band in more detail.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1175338/image.png)
1) if I leave more-less the default setting of the Spectrum Analyzer with Full frequency span and my sampling rate is 96MHz (increasing) then I do not see details of the frequency spectrum well enough and RBW resolution bandwidth increases with sampling frequency (12MHz->24MHz->96MHz) to 93.75kHz.
How to set the Spectrum Analyzer to see the spectrum with fine RBW (~1Hz)?
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1175343/image.png)
2) if I costumize the Span (Hz) then the Spectrum Analyzer requires too many samples (~7M). Can I get lower the number of samples?
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1175348/image.png)
3) If I use instead of RBW setting the Window length (4096, etc...) then I see the following error:
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1175353/image.png)
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1175358/image.png)
How should avoid (fix) "Output argument "PSD"" error?
How to set the Spectrum Analyzer correctly to see the "fine" Spectrum with RBW = 1Hz?
Can it be set up the Spectrum Analyzer with reasonable "normal" number of samples since I would like to have simulation responsivness?
0 个评论
回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Spectral Analysis 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!