Inverter ADC gain update in Sensorless Field-Oriented Control of Induction Motor?

Question

Zohra Njajra 2022-11-7

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1845673-inverter-adc-gain-update-in-sensorless-field-oriented-control-of-induction-motor

回答： Zohra Njajra 2022-11-9

I did some changes on the motor control blockset model named ' Sensorless Field-Oriented Control of Induction Motor' to adjust it and i used it with a F28069card and a TMDSHVMTRINSPIN. In Current feedback process in the m file of the model, an update of the ADC gain and the SPI stetting is used. When i runned the simulation with my motor and inverter parameters, the simulation results are so satisfied. When i did the pratical implementation, the motor run when it is used in open loop (under 0.2 PU speed) and after that the motor stop runnig. So the closed loop program cannot running. I see that the currents feedback are not real. I would like to know if i should left the ADC gain update in the m file or with my inverter, i should not consider it. Just i want to note that if i take the ADC gain=1, the simulation results are not satisfied any more.

open_system('mcb_acim_foc_sensorless_f28379d.slx');

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

KrishnaKumar 2022-11-9

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1845673-inverter-adc-gain-update-in-sensorless-field-oriented-control-of-induction-motor#answer_1094833

The example using mcb_acim_foc_sensorless_f28379d.slx is set to work without any changes with "LAUNCHXL-F28379D controller + BOOSTXL-DRV8305 inverter" hardware board.

Since you are using F28069 with TMDSHVMTRINSPIN, the model needs to be modified appropriately to suit the hardware in use. You can check out Sensorless Field-Oriented Control of PMSM Using C2000 Processors - MATLAB & Simulink (mathworks.com) to get an idea of how to set the Hardware parameters for the hardware that you are using.

Since the simulation seems to work after your modification, the discrepancy between simulation and hardware deployment is most likely due to hardware configurations and hardware dependent parameters being incorrect.

Since you have mentioned that the current measurement is not OK in hardware, I would also recommend that you independently verify the current measurement in Hardware before running the motor in closed loop to eliminate/correct this issue.