MPC output(mv) is zero

3 次查看（过去 30 天）
Shivam Bajpai
Shivam Bajpai 2022-12-26
评论： Emmanouil Tzorakoleftherakis 2023-1-27
Good evening, everyone,
I am currently working on the path following simulink model using MPC controller. The parameters are:
mo:3(current states-x,y, theta)
ref:3(reference states-x,y, theta)
mv:(linear velocity, angular velocity)
Simulink model is working without any error but the outputs(mv) from the MPC controller are zero only. I don't know why it is so. Kindly help me with it. I have applied constraints and designed the parameters. I have attached the picture of mymodel below.
  1 个评论
Emmanouil Tzorakoleftherakis
Emmanouil Tzorakoleftherakis 2023-1-27
I suspect the optimization is not converging. Can you check what the optimization status is? You can enable this port directly from the MPC block

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Refinement 的更多信息

标签

产品


版本

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by