Creating a Redundancy system of the LPV_pump_pipe in simulink.

1 次查看（过去 30 天）
lawrence alderton
lawrence alderton 2023-2-21
编辑： lawrence alderton 2023-2-21
I want to create a redundancy system based on the LPV_pump_pipe here:
Fault Diagnosis of Centrifugal Pumps Using Residual Analysis - MATLAB & Simulink (mathworks.com)
I want to basically have the faulty signal come through and after it is analyzed it switches to the original LPV_pump_pipe parameters. After I got this step working I was going to put a fault sensor into the test portion of the LPV_pump_pipe. I don't think the switch is working properly I am having trouble figuring out how to configure it because it is letting both signals pass through. I am probably going to struggle through to figure out how to implement a fault sensor but one step at a time.
Here is the code is linked at the top

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simscape 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by