How can I generate the setup of AC sweep for AC Voltage source in either Matlab or simulink?
显示 更早的评论
How can I generate the AC sweep for AC Voltage source? To simulate analog filter such as Low pass filter, high pass filter or EMI filter, we need AC sweep setup to run simulation. These AC Analysis includes Type of Sweep (Decade), Number of points per decade (100), Start frequency (10), Stop Frequency (100MEG). How can I generate these setup of the AC sweep for AC Voltage source in either Matlab or simulink?
1 个评论
Moetasem
2025-1-17
Please can you tell me how to extract the frequency response of impedance or admittance of your system using the chirp signal?
采纳的回答
Javier Gazzarri
2015-3-27
0 个投票
Hello, Robert,
I believe the Chirp Signal may do the job for you. It is in the Sources section of the Simulink library.
Best regards, Javier
2 个评论
Hong kit Chong
2020-8-3
Hi Javier, this chirp signal is a simulink signal, to convert it into a physical signal, i have to use PS-S. But in this case i cannot feed that into the voltage to the network. Please explain.
Abhradeep
2023-8-2
Feed the output of PS-S to controlled voltage source
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Electrical Sensors 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
