How can I mode the refrigeration cycle considering frosting in the evaporator in simscape
2 次查看(过去 30 天)
显示 更早的评论
I am building a refrigeration system model,at the same time,I need to consider the impact of evaporator frosting,However,in the condenser evaporator (2P-MA) model ,The condensate is assumed to not accumulate on the heat transfer surface, and does not influence geometric parameters such as tube diameter. The condensed water is assumed to be completely removed from the downstream moist air flow.
I can't find the source code of the condenser evaporator (2P-MA) model to modify.however,I have M file for evaporator considering frosting, how can I add M file to simscape, or, is there another solution
Thank you all
0 个评论
回答(1 个)
Yifeng Tang
2023-5-10
Hi Shuping,
You are correct about the condensed water being removed right away (like magic) from the MA domain. Therefore, no accumulation or frosting. The source code for this block is not open, as this is part of the Simscape Fluids add-on library (only the foundation library shows all the .scc codes). I suggest that you reach out to your MathWorks sales rep, or Technical Support, and ask them to re-route this question to the Application Engineering team. We can have a more in-depth discussion that way as your application will likely require extensive customization.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Two-Phase Fluid Library 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!