At line [gnum4,gden4]=series(gnum3,gden3,numK,denK); I have an error called transfer function not proper and I can not figure out why this error is occuring
3 次查看(过去 30 天)
显示 更早的评论
for kd = 0:1:10;
for kp = 0:1:10;
m = 0.01;
g = 9.81;
k = 1;
mu = 0.05;
mum = 0.2;
J = 100;
gnum1 = [m*g];
gden1 = [m mu mum];
gnum2 = [k];
gden2 = [J 0 0];
numK=[kd kp];
denK=1;
[gnum3,gden3]=series(gnum1,gden1,gnum2,gden2);
[gnum4,gden4]=series(gnum3,gden3,numK,denK);
[numcl,dencl]=feedback(gnum4,gden4,1,1,-1);
sys = tf(dencl, numcl)
rlocus(sys);
hold on
pause(0.5)
end
end
0 个评论
回答(1 个)
cdawg
2023-6-29
This is happening because your numerator numK has more degrees than your denominator denK, making it not proper. I think you may have these variables switched. You can also check if your system is proper by using isproper.
Also, I'm not sure if you're doing this on purpose, but tf takes the inputs tf(numerator, denominator). Right now, you have tf(den,num).
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Dynamic System Models 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!