switch case

30 次查看（过去 30 天）
shahid Alam
shahid Alam 2011-10-28
评论： ahmed al-kady 2015-11-9
i need help here...to run a system in simulink an error is showed : Port 2 of 'final/Subsystem4/Subsystem2/Switch Case' can only be connected to an action subsystem and may not be connected to more than one action subsystem....if possible plz help me here.....

请先登录，再回答此问题。

采纳的回答

Fangjun Jiang
Fangjun Jiang 2011-10-28
The message is clear. The output of the "Switch Case" block can only be connected to one (and only one) "Switch Case Action Subsystem" block, which can be found in library "Ports & Subsystems". Remember to connect the "Action Port", not the "Inport".
Open sl_subsys_sw1.mdl to see an example.

更多回答（1 个）

shahid Alam
shahid Alam 2011-10-28
tnx for your reply. according to your advice I used two different subsystems one is 'Switch Case Action Subsytem' and another is 'Function-call Subsystem'.It is showing same error.If u say that I cant connect two sub systems at the output of switch case then plz give me a solution. And in case of "Switch Case Action Subsytem" i need to use two inputs so if i just add another input inside of its (Switch Case Action Subsytem)mask, will be it okay? If it is possible I would like to share my simulink(.mdl) file to check it by yourself. thanks in advance.
  2 个评论
Fangjun Jiang
Fangjun Jiang 2011-10-28
The output of the "Switch Case" block is a trigger. It can only trigger one subsystem. If you need to trig more than one, you can probably put all the things that you want to trig inside the "Switch Case Action Subsytem".
You can add as many Inport blocks as you want.
ahmed al-kady
ahmed al-kady 2015-11-9
please i need to reset the switch case after triggering another case, as it hold the output even if the input signal is changed. thanks in advance.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Schedule Model Components 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by