Encoder block in Simulink not resetting properly

Question

Richard Balogh 2023-6-15

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1983549-encoder-block-in-simulink-not-resetting-properly

评论： Osama Ahmad 2024-2-21

Since the R2021b, Simulink hardware support for Arduino introduced also the rotary Encoder block: https://www.mathworks.com/help/supportpkg/arduino/ref/encodersensors.html

This block offers an ability to reset counter either regularly at sample time or using an external signal. Unfortunately, external signal reset simply doesn't work. It resets the counter in regular intervals, regardless of the reset input state. To me, it seems like a bug, but maybe I didn't catch something.

As you can see from the following image, Encoder is counting (blue line) regardless of the state at the Reset input (yellow), but then it's zeroing itself regularly.

I am using R2023a, Simulink Support Package for Arduino Hardware with Arduino UNO, and operating in Connected IO mode

Any advices, please?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Swathi 2023-6-21

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1983549-encoder-block-in-simulink-not-resetting-properly#answer_1259674

RotaryEncoderFix.zip

The issue of not being able to leverage the external signal to reset the Rotary Encoder block has now been fixed.

To resolve this issue follow the instructions given below:

Download the files within the attached zip file and put them in the same folder.
Navigate to the folder created in step 1 above in MATLAB.
Run the 'applyPatch.m' file from MATLAB command prompt.
Restart MATLAB.

2 个评论
显示无隐藏无

Richard Balogh 2023-6-23

Confirming, after patching everything works as expected. Thanks!

Osama Ahmad 2024-2-21

I am trying to get encoder values using the rotary Encoder block. The encoder is reading the ticks generated by a pendulum.It is working perfectly fine for Arduino Uno but for a Due board, it shows a drift in the aquired sensor value over time. the difference between the two results can be seen in the attached screenshots (1: Arduino Uno - 2: Arduino Due). Everything works fine if I use the Arduino IDE and the encoder library(therefore the Arduino Due hardware is working fine).

I am running the model in external mode with Arduino as target. Fixed time step of 0.001and solver selection is auto, no clash with pin map as i am using pin 2 and 3 for the signals A and B respectively.The simulation target and code generation languages are C. Using Matlab 2021b.

Is it a bug or am i doing soemthing wrong here?

请先登录，再进行评论。

Answer 2

Cris LaPierre 2023-6-16

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1983549-encoder-block-in-simulink-not-resetting-properly#answer_1257629

I get the same behavior when I test it. I would suggest reporting this here: https://www.mathworks.com/support/contact_us.html

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Richard Balogh 2023-6-16

OK, I will contact them.

请先登录，再进行评论。