how to use ranova with repeated repeated measurements

5 次查看（过去 30 天）
Jonas
Jonas 2023-7-6
评论： Jonas 2023-7-10
Ran in:
dear community,
I have an experiment where 12 subjects were measured during 2 tasks and during each task, a certain value was measured 6 times (here during 6 tones). how can I use ranova on that? not only the 6 values of one instance may correlate but also over the 2 tasks those values may correlate. I want to know if the given response differs between T1 and T2. At the moment I use a variable called Tx to use it as factor, but I doubt that this is the right way:
load('rmtable.mat','rm_tbl');
rm = fitrm(rm_tbl, 'tone1-tone6 ~ Tx', 'WithinDesign', 1:6);
ranova_results = ranova(rm);
% this will give the significance of the the factor Tx ?
ranova_results{'Tx:Time','pValue'}
ans = 0.7101
best regards
Jonas

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Repeated Measures and MANOVA 的更多信息

标签

产品


版本

R2022a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by