What is the output sample rate of the below given code?

3 次查看（过去 30 天）
Shubham Singh
Shubham Singh 2023-7-28
评论： Shubham Singh 2023-8-1
Link - https://in.mathworks.com/help/comm/ug/p25-spectrum-sensing-with-synthesized-and-captured-data.html

请先登录，再回答此问题。

回答（1 个）

Daniel
Daniel 2023-7-28
Per the comments, the output sample rate is 4800, but the more important question would be what the upsampling ratio is.
  • The rctFilt object upsamples the input by a factor of sampsPerSym, which is 4.
  • The d2 object upsamples that by a factor of the first argument, which is 2.
Between those two stages you get an upsampling factor of 8, so the output frequency is 8x the input frequency.
The output is then truncated to the same length as the input, which corresponds to 1/8 of the timespan represented by the input.
  5 个评论
显示 3更早的评论
Daniel
Daniel 2023-7-31
That looks similar to what I see when I plot the spectrum with plot(20*log10(abs(fftshift(fft(y))))). The peaks are a little clearer when you plot in magnitude than when you plot in dB. Since the signal appears to be using the full spectrum and it's flat across the spectrum, you don't get a very obvious delineation between frequency peaks. I'm fairly sure this is by design, though I'm not specifically familiar with C4FM.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Spectral Measurements 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by