xpc realtime udp receive

2011 11 3
4 个回答
38 次查看（30 天）

0 个投票

Does anybody have a short example how to use an xpc realtime udp receiver block? I am able to write out an udp packet to a "sensor" which will answer after receiving the packet. To check the answer, I am using wireshark. But I am not able to receive this packet with the xpc target.
It seems to me, that the xpc realtime receiver block is misconfigured or has a bug, may be the packet size is too short?
Was anybody able to use this receiver block successfully?

请先登录，再回答此问题。

回答（4 个）

Peter Wehrli
Peter Wehrli 2011-12-21

0 个投票

There is a bug in the realtime udp receiver block. Below a certain amount of bytes, the block will not receive any byte. Actually I am testing a patch of MathWorks. In a short time the patch will be available on MathWork's support page.
Mirko Kunze
Mirko Kunze 2012-3-22

0 个投票

Any updates on this issue? I have the same problems and did not find any patches.
Peter Wehrli
Peter Wehrli 2012-3-22

0 个投票

go to bug report 783622 (xpc target, 2011b), there you will find the update!

2 个评论
显示 无 隐藏 无

Celine Chia
Celine Chia 2012-6-11
Erm,
how do you do you find the bug report 783622? do you have the link?
I googled it and nothing.
Walter Roberson
Walter Roberson 2012-6-11
Bug reports can generally be found at http://www.mathworks.com/support/bugreports/
That particular one is either not present or not publicly visible.

请先登录，再进行评论。

Rajiv Ghosh-Roy
Rajiv Ghosh-Roy 2012-6-11

0 个投票

Bug report link.
I think you need to set the "release exists in" to R2011b.

类别

在 帮助中心 和 File Exchange 中查找有关 System Configuration 的更多信息

产品

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by