error while build deploy and start the model tc4x_8ledsBlinky

Question

MatlabUser168 2023-10-16

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2033969-error-while-build-deploy-and-start-the-model-tc4x_8ledsblinky

回答： Abhishek GS 2024-11-6，10:05

when i build deploy and start the model tc4x_8ledsBlinky follow the illstrucation https://ww2.mathworks.cn/help/supportpkg/infineonaurix/ug/getting-started-led-example.html

Required Software

Launch hardware setup and install the following third-party tools. For more information, see Supported Hardware and Required Software.

iLLD for TC4x family
TASKING SmartCode for TriCore
Infineon MemTool

Required Hardware

To run this example, you will need the following hardware:

Supported Infineon AURIX TC4x board (STD or COM)
USB cable

i have the hardware and software ,and the PINOUT was configured as COM ,i don't know what is the wrong?pls help ,thanks!

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Asim 2024-9-25

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2033969-error-while-build-deploy-and-start-the-model-tc4x_8ledsblinky#answer_1522410

Hello,

I've successfully regenerated the example on my end. Could you please double-check the steps you've followed? If you encounter any errors during the process, kindly attach a screenshot or copy of the error message, along with the configuration parameters you've used. This information will greatly assist in troubleshooting the issue.

Thank you.