I understand that you wish to send data from the MATLAB command window to a Simulink model.
For this you can create a TCP connection from MATLAB and set it as a server. Then you need to enter the same address and port number in the “TCP/IP Receive” Simulink block .
You can refer to the following example for setting up model parameters and establishing a connection in Simulink:
For transferring data from the MATLAB Command Window to Simulink you can try out the following example:
I have tried the following at my end:
MATLAB script:
server = tcpserver('0.0.0.0',4000,ByteOrder="big-endian",ConnectionChangedFcn=@connectionFcn)
sim("simul.slx");
function connectionFcn(src, ~)
if src.Connected
freq = 1; % frequency (Hz)
time = (0:1/(freq*100):1);
amp = 1; % amplitude (V)
phi = 0; % phase
data = amp*sin(2*pi*freq*time+phi);
write(src,data,"double");
end
end
Simulink Model:
Output Produced:
You can also refer to:
Hope this helps!!
