error while ploting and save

3 次查看（过去 30 天）

显示更早的评论

Shaukat 2023-10-20

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2036146-error-while-ploting-and-save

评论： Walter Roberson 2023-10-20

When run show this error even Mapping Toolbox is installed

Warning: Probably because you do not have Mapping Toolbox, getar was performed by an approximative method.

> In getar (line 24)

2nd not save figures

5 个评论
显示 3更早的评论隐藏 3更早的评论

Shaukat 2023-10-20

Can some guide mefor right person who resolved my simple issue .ie., why not my installed matlab not save figure.?

Walter Roberson 2023-10-20

在 MATLAB Online 中打开

Experiment with giving the command

restoredefaultpath; rehash toolboxcache

and then run your code again. If the code starts working then you have a function somewhere on your path (such as a third-party toolbox) that has the same name as a Mathworks function and is interfering with the Mathworks function. If the code does not start working, then there might still be the same problem but with the interfering function being in your current directory.

I notice that the error message does not give a line number within printopt even though that is .m source code, such as at toolbox/local/printopt.m . That hints that you are somehow invoking a different printopt .

The supplied printopt does not itself check the number of input arguments, and ignores its input arguments. It calls upon the functions isempty, message, strcmp, system_dependent, warning (and also ispc but does not supply any parameters to that call). All of those are important internal functions; if you are somehow redefining those then you would have run into a lot of other problems. So I would tend to suspect that the problem would be in a different printopt being invoked.

请先登录，再进行评论。

请先登录，再回答此问题。