Read OK but I can't Write in PLC by TCP/IP client.

6 次查看（过去 30 天）
José Rudiney De Sousa Miranda Júnior
回答： SANKALP DEV 2023-12-15
I have a comunicatio betwen PLC Mitsubhishi Q03UDE and MatLab by TCP/IP. I can read register and memories, but I cant write. When I use the 'write' command to request the reading of the registers, it returns the values correctly. However, when I try to use 'write' to write into the PLC, it doesn't write.
% Define the frame structure
frame.header = [hex2dec('50'), 0, 0, hex2dec('ff'), hex2dec('ff'), 3, 0];
frame.length = [hex2dec('0c'), 0];
frame.timer = [hex2dec('20'), 0];
frame.command = [1, 4];
frame.sub_command = [1, 0];
frame.start_addr = [hex2dec('64'), 0, 0];
frame.device = hex2dec('90');
frame.points = [8, 0];
frame1.header = [hex2dec('50'), 0, 0, hex2dec('ff'), hex2dec('ff'), 3, 0];
frame1.length = [hex2dec('10'), 0];
frame1.timer = [hex2dec('20'), 0];
frame1.command = [1, hex2dec('14')];
frame1.sub_command = [0, 0];
frame1.start_addr = [hex2dec('64'), 0, 0];
frame1.device = hex2dec('a8');
frame1.points = [1, 0];
frame1.w_data = [hex2dec('64'), 0];
s = tcpclient('192.168.3.38', 2500, 'Timeout', 10);
write(s, uint8(struct2array(frame)));
data = read(s, 15);
write(s, uint8(struct2array(frame1)));

请先登录，再回答此问题。

回答（1 个）

SANKALP DEV
SANKALP DEV 2023-12-15
Hello Jose,
I understand that you are experiencing difficulties with writing data to a Mitsubishi PLC (Q03UDE) from MATLAB using TCP/IP communication.
To resolve the issue, you can consider implementing robust error handling using try-catch blocks in MATLAB to capture and display any exceptions that may occur during communication and utilize MATLAB debugging tools to step through the code, inspect variable values, and print/display intermediate results for better visibility.
Wrapping the code in a try-catch block will allow you to catch any exceptions that may occur during the execution of the code and handle them appropriately.
Secondly, you can also add a delay between writing the first and the second frame, the delay is necessary to allow the plc sufficient time to process the write operation. You can use MATLAB’s ‘pause’ function to add delay.
Refer to the following documentation to know more about try, catch statements, and ‘pause’ function respectively in MATLAB: -
I hope it helps.
Thanks, and regards,
Sankalp dev.

类别

在 Help Center 和 File Exchange 中查找有关 Data Import and Analysis 的更多信息

标签

产品


版本

R2023b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by