Simulation error in my powertrain modeling simulation

3 次查看（过去 30 天）
Syed Anass
Syed Anass 2023-11-24
评论： Sayan 2023-12-4
FACING THE ISSUES MENTIONED BELOW I DON'T KNOW WHAT TO DO NOW WHAT EVER I DO, THERE IS NO BETTERMENT HAPPENING IN THE SIMULATION OF THE BATTERY MODEL OF A BATTERY PACK. KINDLY SOMEONE HELP ME IN THIS ITS URGENT.
'Output Port 1' of 'batteryModel2november/Constant' is not connected.
Ungroup 6 similar
Component:Simulink | Category:Block warning
'Output Port 1' of 'batteryModel2november/Signal Builder' is not connected.
Component:Simulink | Category:Block warning
'Output Port 2' of 'batteryModel2november/Signal Builder' is not connected.
Component:Simulink | Category:Block warning
'Output Port 3' of 'batteryModel2november/Signal Builder' is not connected.
Component:Simulink | Category:Block warning
'Output Port 4' of 'batteryModel2november/Signal Builder' is not connected.
Component:Simulink | Category:Block warning
'Output Port 1' of 'batteryModel2november/Signal Builder1' is not connected.
Component:Simulink | Category:Block warning
First solve for initial conditions failed to converge. Trying again with all high priorities relaxed to low.
Component:Simulink | Category:Model warning
Unable to satisfy all initial conditions. The variables involved are listed below. The following variables are involved in a constraint that conflicts with their targets: 'Subsystem20.Cell1.cell_temperature' (Temperature) Here are the equations involved: all components involved'batteryModel2november/Subsystem20''batteryModel2november/Subsystem20/Cell1'Equation location is: 'C:\Program Files\MATLAB\R2023a\toolbox\physmod\battery\shared_library\m\+batteryecm\table_battery.sscp' (no line number info) 'batteryModel2november/Subsystem20/T_amb1'Equation location is: 'C:\Program Files\MATLAB\R2023a\toolbox\physmod\simscape\library\m\+foundation\+signal\+sources\constant.ssc' (line 21) 'batteryModel2november/Subsystem20/convection1''batteryModel2november/Subsystem20/convection1/constant T'Equation locations are: 'C:\Program Files\MATLAB\R2023a\toolbox\physmod\simscape\library\m\+foundation\+thermal\+sources\controlled_temperature.ssc' (line 33) 'C:\Program Files\MATLAB\R2023a\toolbox\physmod\simscape\library\m\+foundation\+thermal\+sources\controlled_temperature.ssc' (line 34)
Component:Simulink | Category:Model warning
An error occurred while running the simulation and the simulation was terminated
Caused by:
  • ['batteryModel2november/Solver Configuration']: At time 1696.547995, one or more assertions are triggered. See causes for specific information.
  • Temperature adjusted first time constant must be greater than zero. The assertion comes from: Block path: batteryModel2november/Subsystem20/C150Assert location: o (location information is protected)
Component:Simulink | Category:Block error

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Nonlinear Operators 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by