Displaying simulation results (external mode)

2011 11 9
2 个回答
5 次查看（30 天）

1 个投票

I use external mode simulation to control balancing robot (RT-DAC/PCI-Real-Time Data Acquisition Board). While using LQR controller I could observe (each) results in scope (control signal, angle etc.) in real time. When I applied fuzzy controller with 25 roles robot operates very gut but I can not observe performance of control signal however deflection of robot is displayed good.. Even if I want to save the results (block 'To Workspace') I get only '0' or sometimes some of values are very small and seem to be random. What should I do to observe also control signal? I've heard that it can be problem with to high computing precision and board/Simulink doesn't follow up to display all (with fuzzy controler) results properly. How can I decrease the computing precision? Than you for any advice.

请先登录，再回答此问题。

回答（2 个）

Lukasz Wajdzik
Lukasz Wajdzik 2011-11-9

1 个投票

Thanks, but it didn't help.. I did set everything properly but it still works badly. What is interesting now even deflection of the pendulum is displayed wrongly, and fuzzy control signal is continuously zero. However robot is balancing very well.. If I delete fuzzy controler block from the simulation everything is displayed well, so the problem seems to be with this..
Uday M
Uday M 2011-11-9

0 个投票

Hi Lukasz,
For the issue of observing/logging signals, please refer to: Logging Signals To the Base Workspace
-U

类别

在 帮助中心 和 File Exchange 中查找有关 Fuzzy Logic in Simulink 的更多信息

产品

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by