Help with non-linear block spring mass system

1 次查看（过去 30 天）
Cristian Rohozneanu
回答： Fangjun Jiang 2024-2-1
How can I add a block for the nonlinear term so that I can simulate the system?
  3 个评论
显示 1更早的评论
Fangjun Jiang
Fangjun Jiang 2024-2-1
The nonlinear part is the k() function. It is simple enough to construct it using blocks.
The block diagram is far from the correct implementation. Use two integrators to construct q1, two integrators for q2, two integrators for q3. And then construct the rest.
Cristian Rohozneanu
Cristian Rohozneanu 2024-2-1
Hi @Fangjun Jiang
This implementation of the scheme is done without considering the nonlinear term, in the first part I didn't need it, I just need to add now and simulate the system with the nonlinear part.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Fangjun Jiang
Fangjun Jiang 2024-2-1
  1. Use two integrators connected in series to construct q1. The output is q1, the input is "q1 two dot". In the middle, it is "q1 dot".
  2. Do the same for q2 and q3
  3. Then you have Delta1=q1-q2, Delta2=q2-q3
  4. k(Delta1)=K0*Delta1+K1*(Delta1)^3 should be easy. You can even make it a function to apply the same for Delta2
  5. Then connect the signal lines in Simulink according to the last three lines of your equations. You will have the correct Simulink implementation of your mathmatical equations.

类别

在 Help Center 和 File Exchange 中查找有关 General Applications 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by