Single line diagram measurements, Simulink

13 次查看（过去 30 天）
Kim
Kim 2024-2-19
Hello, I've tried to make measurements on a single line diagram (3-phase) with a sensor but when I run the simulation I'm met with a model warning/error in the diagnostic viewer: "First solve for initial conditions failed to converge. Trying again with all high priorities relaxed to low.". I'm not sure what the problem is or if there are better ways to do measurements on a single line diagram. Thank you for your help in advance.

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Configure and View Diagnostics 的更多信息

标签

产品


版本

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by