How to display the values of a Stateflow local data during simulation.

4 次查看（过去 30 天）
Mirko Mirabella
Mirko Mirabella 2024-2-20
评论： Mirko Mirabella 2024-2-20
Good morning, I am writing this request to gather some information on how to monitor the behavior of a local Stateflow variable during simulation. Currently, the only method I have found is to convert it into an output and visualize it on a logic analyzer, but I believe this is a less efficient approach.

请先登录，再回答此问题。

回答（1 个）

Aquatris
Aquatris 2024-2-20
I think this is what you are looking for.
Essentially you define the variable in your stateflow as a logged data (from Property Inspector), and when you run your simulation, it automatically sends the data to the matlab workspace. You then can see it via
myData = get(logsout,"myData");
myData.Values
  1 个评论
Mirko Mirabella
Mirko Mirabella 2024-2-20
Thank you Acquatris for your response. I have tested and verified this method on other occasions. I was wondering if there is a way to monitor the trend of the variable during simulation, similar to the display on the logic analyzer.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Complex Logic 的更多信息

标签

产品


版本

R2023b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by