Hello Sonam,
For the first error while using the induction motor, I would recommend you to check that the motor parameters are consistent with the system. I would also recommend you testing out different solvers. It is a common resolution for such errors.
For the load flow data error, this issue is occurring because the number of iterations required to converge is more than the max iterations limit defined in “powergui” block.
Please follow the steps mentioned below to resolve this problem:
- Open the “powergui” block and make sure the “Simulation type” is discrete.
- Navigate to “Preferences” tab.
- Expand solver details for nonlinear elements.
- Enter a large value in the Maximum number of iterations.
Please refer to the documentation attached below for more information.
I would highly recommend you to go through the following MATLAB Answer which addresses the same issue as well:
I hope this resolves your issue.
