Heat transfer area in single and two phase pipe
5 次查看(过去 30 天)
显示 更早的评论
Hi,
Is there a method to change the heat transfer area in a pipe (TL) and pipe (2p)? The existing blocks consider the entire area (i.e. perimeter x length of the pipe), however if we only want to consider a section of this to be the heat transfer area (say for a pipe with rectangular cross section, we only consider one of the faces to be the area of heat tranfer) how would we get that done. Do we need to build a custom block for this, or is there another block?
Thanks
0 个评论
采纳的回答
SOUMNATH PAUL
2024-4-8
Hi,
MATLAB/Simulink does not offer a standard block specifically designed to adjust the heat transfer area in pipes to only a section of the surface.
You will likely need to create a custom block to specify a different effective heat transfer area.
Here is how you can do it, refer to the following link:
For a pipe with regular cross-sectional area where only one face is used for heat transfer, we can calculate the effective area as , (A_{eff} = Width/ times Length)
Kindly adjust the input parameters in existing blocks to use the effective area instead of full pipe surface area.
Thanks,
Soumnath
0 个评论
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Elements 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!