variable duty ratio to a switch at different time intervals

13 次查看（过去 30 天）
KESARI HANUMANTHU
KESARI HANUMANTHU 2024-4-12
评论： Manikanta Aditya 2024-4-13
I want to supply a gate pulse to an IGBT switch in DC-DC converter with a duty ratio of 40% from 0 to 2 seconds and 2 to 4 seconds with simulation time of 6 seconds and i want to disconnect the gate pulse to switch from 4 to 6 seconds. how to do this in simulink. The switching frequency of IGBT switch is 20 kHZ.
  6 个评论
显示 4更早的评论
Fangjun Jiang
Fangjun Jiang 2024-4-12
@Manikanta Aditya, which Pulse Generator block are you referring to? I didn't find the place to "Define Variable Duty Ratio in Pulse Type Attributes".
Manikanta Aditya
Manikanta Aditya 2024-4-13
I meant the Pulse Generator block in Simulink that allows defining a variable duty ratio based on time.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Fangjun Jiang
Fangjun Jiang 2024-4-12
I assume this is in Simulink. You can use an AND logic block or Product block to multiply two signals. One is the regular 40% duty cycle PWM all the time, the other is this On/Off signal based on pre-determined timing or based on event by other Simulink signal.
  3 个评论
显示 1更早的评论
Fangjun Jiang
Fangjun Jiang 2024-4-12
You could use a Signal Builder block. Or use a Switch block, before t<4, pass the PWM. After that, switch to 0.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Pulse and Transition Metrics 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by