MATLAB Fault Analysis - "Continuous-time signals support faults only if its destinations are discrete" Error Command
1 次查看(过去 30 天)
显示 更早的评论
I am trying to trigger a fault in MATLAB for my simulation, so I can get some disturbance in my current simulation outputs. However, it is not working and I am getting the following error:
Fault Inport block 'Fault_Analysis_FaultModel/output_fault/Fault Inport' is set to read/override invalid signal on the Outport number 1 of block 'Fault_Analysis/Current'.
Caused by:
- Target signal is a continuous-time signal. Continuous-time signals support faults only if its destinations are discrete.
At the moment, I have triggered a timed fault at 10 sec. How can I fix this issue? Is there another way I can achieve the same goal? Any support is much appreciated.
0 个评论
回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Troubleshooting 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!