How to simulate my custom drone in jMAVSim with Matlab PX4 simulink ?

13 次查看（过去 30 天）
Karukkuvel Raj
Karukkuvel Raj 2024-5-2
评论： Mariam Amin 2024-7-9
I simulated a custom drone by replacing the STL files and Simulator.java file in the tools/simulation/jmavsim folder. And when i run the jMAV simulation from the PX4 make commands jMAVsim loads the custom model I given to it. But when I try to launch jMAVsim via simulink it loads the default 3dr_quadrotor. Kindly help me to load the simulator with my custom model when launching via simulink
  3 个评论
显示 1更早的评论
Karukkuvel Raj
Karukkuvel Raj 2024-5-2
yes, " make px4_sitl jmavsim " loads my quadcopter model when entered from the terminal.
But when i click monitor & tune from simulink it (jMAVsim) only loads the default quad model.
Mariam Amin
Mariam Amin 2024-7-9
Hello, can you please tell me which stl files did you replace ? did you replace teh default aircraft files in the model folder?

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Arun Mathamkode
Arun Mathamkode 2024-6-11
Based on my undertsanding the only difference is, from Simulink the SITL and jMAVSim are launched seperately. I am not sure how that is impacting the visualization. I assume you replaced the STL file and its name and locations are unchanged, so the jamvsim should fetch the new model by default. Simulink is not looking for any specific vehicle type and whatever jMAVSim fetches by default is displayed.
One workaround I can think is do monitor and tune from Simulink and then stop the simulation and manually launch the SITL and jMAVSim using make command. Then do connect from Simulink. Have alook at Disconnect and connect section of this documentation.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simulink 3D Animation 的更多信息

标签

产品


版本

R2024a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by