Error while running monitor and tune on zedboard using matlab_2023 and xilinx2019.2

1 次查看（过去 30 天）
anuj maheshwari
anuj maheshwari 2024-5-2
回答： Abhishek Kumar Singh 2024-5-3
The hdl coder runs fine and I am able to upload the example code from led blinking example : hdlcoder_led_blinking. The code uploads to the zedboard and I can see the led's glowing. The problem happens when I try to run the interface file. I don;t see the monitor and tune option in the toolstrip, but i see the "configure, monitor and tune" option and when I click on it, I see the error : Error:FPGA or processor model not detected. You must launch SoC Builder from the top model. If the error persists, see Build Error for FPGA or Processor Model not Detected.
I am attaching a screenshot for reference. Any help will be appreciated.

请先登录，再回答此问题。

回答（1 个）

Abhishek Kumar Singh
Hi Anuj,
To get the "Configure, Monitor & Tune" option working, you need to build your model with socBuilder as the error suggests. Just open the Command Window and type:
socBuilder('modelname')
For details on SoC Builder, check the documentation here: https://www.mathworks.com/help/ti-c2000/ug/socbuilder.html
Also, the "Configure, Monitor & Tune" option is under the MONITOR & TUNE section in the Hardware tab.
If you're still stuck after this, the solution might be in the troubleshooting steps here:
https://www.mathworks.com/help/soc/ug/build-error-for-fpga-or-processor-model-not-detected.html

类别

在 Help Center 和 File Exchange 中查找有关 Intel FPGA and SoC Devices 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by