Error:External Mode Open Protocol Connect command failed Caused by: Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNEC

110 次查看（过去 30 天）
CHIANG
CHIANG 2024-5-6
评论： Abinesh 2025-3-26
External Mode Open Protocol Connect command failed
Caused by:
  • Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command
How To fix this problem?
  2 个评论
Vamsi krishna
Vamsi krishna 2025-1-17
Did you try to fix this ? I'm getting the same error on f28379d control card. However, this error only appears in the "Monitor and Tune" mode and not during "Bulid, Deplay & Load"
Abinesh
Abinesh 2025-3-26
Vamsi krishna
Did you solve this issue same problem is with me also how to resolve this issue.
Error:External Mode Open Protocol Connect command failed
Caused by:
Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command
Error:Unable to connect to the 'TI Delfino F28379D LaunchPad' target for 'mcb_open_loop_control_f28379d'.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Venkat Siddarth Reddy
编辑：Venkat Siddarth Reddy 2024-5-6
Hi Chiang,
Refer to the following post regarding this query, since this consolidates various approaches in solving the issue:
https://www.mathworks.com/matlabcentral/answers/2019856-error-could-not-connect-to-target-application-xcp-internal-error-timeout-expired-in-response-to?s_tid=answers_rc1-1_p1_MLT
I hope it helps!

类别

在 Help Center 和 File Exchange 中查找有关 Deployment, Integration, and Supported Hardware 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by