How does transfer signals through store memory swapping in different software components? use the System Composer toolbox.

Question

鑫鹏 2024-5-9

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2116841-how-does-transfer-signals-through-store-memory-swapping-in-different-software-components-use-the-sy

评论：鑫鹏 2024-5-24

Hi,

I am using System Composer to build software architecture and ultimately implement code generation.

My software architecture includes multiple parallel running tasks, and I use different components in the system composer to represent them.

Different components plan to use swapped memory for signal transmission. For example, the sensor module will receive data from external sensors for processing, and then transmit the processed signal to other tasks for calculation.

Our software architecture plan will be implemented using the following methods. Store memory and store write models were created in the sensor module for signal transmission. In the task module (task 2), use the store read module to read the signals written into memory by the sensor module.

However, during the simulation process, it was found that the data written by the sensor module could not be read in the task component. Is there any suggestion to implement this architecture?

Thanks,

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

鑫鹏 2024-5-11

I changed the software architecture and created two subsystems in the Simulink model within the same component, and then used the data store memory module again to achieve signal sharing between the two subsystems. Then, still use port and interface to pass messages between components. This strategy is feasible. Does this mean that the System Composer cannot support different components exchanging signals through shared memory?

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Josh Kahn 2024-5-15

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2116841-how-does-transfer-signals-through-store-memory-swapping-in-different-software-components-use-the-sy#answer_1458256

Hi @鑫鹏,

Shared memory can be modeled using client server ports in the Software Architecture template in System Composer. I have a quick introduction here:

https://www.youtube.com/watch?v=RsB6ARyflIQ&t=2s

Hope this helps,

Josh

2 个评论
显示无隐藏无

Josh Kahn 2024-5-15

Also see example: https://www.mathworks.com/help/systemcomposer/ug/service-oriented-sensor-modeling.html

鑫鹏 2024-5-24

Thank you for your reply. It has been very helpful for me to adjust the software architecture. For the current situation, the interlocking mechanism between global variables has become a relatively difficult problem to handle.

请先登录，再进行评论。