Positioning Subsystem Ports in Simulink/Simscape via MATLAB Code (LConn / RConn)

Question

Raphael 2024-5-23

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2121821-positioning-subsystem-ports-in-simulink-simscape-via-matlab-code-lconn-rconn

编辑： Sayan 2024-5-29

Dear Community,

I'm currently working on my master's thesis and attempting to create a Simulink/Simscape model directly from MATLAB. I aim to consolidate certain "Building Blocks" that are used repeatedly into a subsystem for the sake of clarity. My goal is to position the ports of this subsystem directly from MATLAB.

Presently, I have a result that looks similar to the attached image.

However, I wish to rearrange the ports, all of which are currently situated on the left side of the subsystem, so that they are positioned as follows (Manual Post-Processing Performed):

In my attempts thus far, I've encountered the issue that the ports are set as "read-only," preventing me from defining their positions. I've tried to set the position as follows:

subsystem_block = "path_to_subsystem"
port_handles = get_param(subsystem_block, 'PortHandles')
N = length(port_handles.LConn)
newx = 1:N % example
newy = 1:N % example
for k = 1:N
set_param(port_handles.LConn(i), 'Position', [newx(k), newy(k)]);
end 

Unfortunately, this yields the error message "Port parameter 'Position' is read-only."

Is there a way to set the position of the ports of the subsystem directly from MATLAB? If so, could someone explain how to do it? If not, what alternatives would I have if I still want to utilize a sort of "Building Block"?

Any assistance would be greatly appreciated!

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Sayan 2024-5-29

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2121821-positioning-subsystem-ports-in-simulink-simscape-via-matlab-code-lconn-rconn#answer_1464781

编辑：Sayan 2024-5-29

在 MATLAB Online 中打开

Hi Raphael,

I too have faced the same issue. It seems the position of the ports (both Simulink ports and Physical ports) on the subsystem interface cannot be changed directly from MATLAB programmatically because the properties are read-only. Only way to do this is through Simulink.This seems to be intended behavior. However, you can change the side of the "Connection port" programmatically.

set_param('Path to your Connection port block inside subsystem','side','Right')

You can check out a similar kind of issue addressed in the following MATLAB answer.

https://www.mathworks.com/matlabcentral/answers/31981-change-the-position-of-a-part-of-the-input-ports-of-a-simulink-block

Hope this helps.