delete zero in signal

2 次查看（过去 30 天）
洪宇
洪宇 2024-6-19
回答： Aquatris 2024-6-19
My current signal is shown in the figure, which can be seen as continuous steps. I want to obtain the vertices of these peaks and then connect them one by one to form a discount, becoming a new signal that can be input into other modules of Simulink. How to achieve this

请先登录，再回答此问题。

回答（1 个）

Aquatris
Aquatris 2024-6-19
Your question is a bit ambigious but if you just want to remove the 0 s from the signal you can use a switch and delay block to ignore 0 values.

类别

在 Help Center 和 File Exchange 中查找有关 Signal Attributes and Indexing 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by