How to use Simulink to gain the oscillation frequency of RLC circuit?

16 次查看（过去 30 天）
baocheng guo
baocheng guo 2015-4-24
编辑： Sebastian Castro 2015-5-8
I have a RLC system as below, the question is how i use the Simulink to gain the oscillation frequency because solving the equations sounds too low, lol. The signal builder is used to emit a impulse signal and the spectrum analysis is used to calculate the frequency, and I don't know is it right? because the result seems wrong. If it is wrong, how i should do to gain the frequency?

请先登录，再回答此问题。

回答（2 个）

Sriram Narayanan
Sriram Narayanan 2015-5-4
It is not very clear when you mentioned "How I use Simulink to gain the oscillation frequency"? Can you please explain more about your use case and share your model if possible?
  1 个评论
baocheng guo
baocheng guo 2015-5-8
编辑：baocheng guo 2015-5-8
Thank u for ur answer, and this question is very simple.
As we know, when the circuit has a inductance (L) and capacitance (C), when give a certain voltage, such as V= Ecosw, the storage energy of L and C will equal, and it is will oscillation. The frequency of the voltage is defined as f=sqrt(L/C)/(2*pi), e.g., L = 1, C = 1,and the f could be gain as 0.159 Hz.
and the 'f' can calculate by formula, but I hope the Simulink can find this frequency auto.
best..

请先登录，再进行评论。

Sebastian Castro
Sebastian Castro 2015-5-8
编辑：Sebastian Castro 2015-5-8
1. I think the Spectrum Analyzer block expects a discrete-time signal... So, you can either change the simulation mode of your model from the powergui block, or use a Rate Transition block on the sensed signals to get them sampled. Of course, you need to make sure your sampling rate is high enough.
2. Another thing people usually do with SimPowerSystems models is use the FFT Analysis tool in the powergui block. This will give you an FFT for those particular simulation results.
To do this, you should measure the current (or voltage) in a Scope block, turn on Structure with Time logging in the Scope, and then pull up that FFT Analysis tool from powergui.
3. I almost forgot, there is also an Impedance Measurement block in SimPowerSystems which can be coupled with the Impedance vs. Frequency Measurement option in powergui. You basically connect this block across the terminals you care about, and then you get an impedance over a specified frequency sweep.
Check that out and see if it gives you the right frequency peak(s).
- Sebastian

类别

在 Help Center 和 File Exchange 中查找有关 Simulation and Analysis 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by