Simulink real-time model execution stops at 1st iteration randomly
1 次查看(过去 30 天)
显示 更早的评论
Hello,
I am using Simulink Real-time for running a vehicle model with actuator inputs given through an ADC(NI PCI-6229). The states are sent over serial. When I build this model and download it to an i386 target it randomly fails to start and gets hung up on the 1st iteration. I have done the following to try to resolve the issue since i have not found any error code for the same:
- Changed my MATLAB 2014a setup to a differnet PC.
- Changed the target PC
- Disconnected all connected hardware
- Changed the SCB-68 connection block
- cleaned all generated files and built the model again
The model runs when I bypass the Analog inputs with constants. The proves that there is some issue with the analog data acquisition block, but i may be horribly wrong. Has anybody come across this issue in the MATLAB 2014a pack?
Swaroop
0 个评论
回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Target Computer Setup 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!