single phase and three phase dynamic load
8 次查看(过去 30 天)
显示 更早的评论
Hello all, My first question is why single phase dynamic load is not in simulink library? Another question, when i simulate single phase dynamic load in any mode(continuous,discrete or phaser)its too slow and if i run for longer time, the memory allocated for matlab is full and doesn't for forward. is there any solution for it? but this is not the case with three phase dynamic load. i am quit surprise with this.
is there any way to use three phase dynamic load for single phase dynamic load?
Many thanks
2 个评论
Tony Castillo
2015-11-6
Hey my friend I am having the same problem than you had in the past, could you share with my how did you surpassed it?, because i am mired with it. I would appreciate any the colaboration on it.
Sebastian Castro
2015-11-6
编辑:Sebastian Castro
2015-11-6
Tony: In case you missed it, I commented again on your question a few days ago.
回答(2 个)
cr28
2012-8-13
Samir,
All i can say is when i simulated a 3-phase dynamic load in phasor mode, the simulation was quick.....a lot quicker than continuous mode.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Electrical Sensors 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!