- https://www.mathworks.com/help/releases/R2023b/supportpkg/parrot/ug/generic-dongle-in-windows.html
- https://www.mathworks.com/help/releases/R2023b/supportpkg/parrot/ug/minidrone-not-found-by-bluetooth-scan.html
- https://www.mathworks.com/help/releases/R2023b/supportpkg/parrot/ug/minidrone-not-found-by-bluetooth-scan-1.html
Parrot Minidrone - Firmware update - HW Setup Error
1 次查看(过去 30 天)
显示 更早的评论
Hello all,
I'd like to update the Firmware on the Rolling Spider Parrot Minidrone. I'm following these steps:
In the step 6 the drone is successfully recognized. But when I click on Next - error occurs after few seconds:
So may I ask you, does anybody experienced this behavior and does anybody know how to proceed? Because it does not seem that Firmware is updated.
Thank you
0 个评论
采纳的回答
Kautuk Raj
2024-9-17
It sounds like you are encountering an issue during the firmware update process for your Rolling Spider Parrot Minidrone.
From the error message, it can be gathered that the “minidrone not detected” part indicates that the Parrot Minidrone was not successfully connected to the system either using the Built-in Bluetooth Module or a Generic Bluetooth Dongle.
I recommend you retry the connection using the steps entailed on this documentation page: https://www.mathworks.com/help/releases/R2023b/supportpkg/parrot/ug/connect-to-hardware-over-bluetooth-windows-drivers.html
You may also refer to these pages to troubleshoot the connection settings:
I hope following the guides will help you successfully update the firmware on your drone.
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 MATLAB Support Package for Parrot Drones 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!