CAN Communication in Simulunk between 2 F28379D Boards

Question

Ahasan urrahman 2024-9-24

回答： Saurav 2024-10-1

Hi,

I wanted to know how to make the can communication work in simulink between 2 F28379D boards, I have not found any resources to help me with it.

Answer 1

Saurav 2024-10-1

For implementing CAN communication between two F28379D boards using Simulink, here are some essential resources to get started:

Basic Prerequisites for C2000 Hardware Boards:

Hardware Setup for C2000 Microcontroller Blockset: Learn how to install and configure the necessary support for C2000 processors. https://www.mathworks.com/help/ti-c2000/ug/install-support-for-c2000-processors.html
Getting Started with Texas Instruments C2000 Microcontroller Blockset: This documentation provides an introduction to using the C2000 blockset with Simulink, including basic examples. https://www.mathworks.com/help/ti-c2000/ug/getting-started-with-C2000-example.html

Setting Up CAN Communication on Target Hardware:

Set Up CAN Communication with Target Hardware: Detailed instructions on setting up the hardware for CAN communication between the target and host computer. https://www.mathworks.com/help/ti-c2000/ug/set-up-the-hardware-for-can-communication-between-the-target-and-the-host-computer.html
Communication Using CAN Blocks: Documentation on using CAN blocks for communication in Simulink models. https://www.mathworks.com/help/ti-c2000/ug/ecan-example.html

These resources should be helpful for the task!