To Change the time base of a given run by an addition or subtraction to all time entries and update of all the plots with this new time base, you can modify the time data of the “timeseries” objects directly in MATLAB by following the below steps:
- Access the run data from SDI using the “Simulink.sdi.getRun” function
- Modify the time data of each signal by iterating through the signals in the run and adjusting their time vectors.
- After modifying the time vectors, the changes should automatically reflect in SDI. If SDI does not automatically refresh, you can manually update or refresh the display.
You can try the below code:
% Retrieve the run ID (replace with your specific run ID)
runID = Simulink.sdi.getAllRunIDs;
myRun = Simulink.sdi.getRun(runID(end)); % Example: getting the latest run
% Define the time offset (positive or negative)
timeOffset = 5; % Example: offset by 5 seconds
% Iterate through each signal in the run
for i = 1:myRun.SignalCount
signal = myRun.getSignalByIndex(i);
ts = signal.Values; % Get the timeseries object
% Modify the time vector
ts.Time = ts.Time + timeOffset;
% Update the signal with the modified timeseries
signal.Values = ts;
end
You can refer the below documentation link for more info on SDI:
