How to generate a .iq file from i q data in matlab?

87 次查看（过去 30 天）
Eric
Eric 2024-11-4，19:37
评论： Walter Roberson 2024-11-5，5:14
How do i generate a .iq file from the i q data from a matlab script exactly? Any help will be appreciated.
  3 个评论
显示 1更早的评论
Eric
Eric 2024-11-4，21:31
编辑：Eric 2024-11-4，21:45
Do you have example matlab code?
Walter Roberson
Walter Roberson 2024-11-4，21:58
No, and I do not see any code posted anywhere for that purpose.
I find MATLAB code for a different .iq file format at https://pysdr.org/content/iq_files.html

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Jaimin
Jaimin 2024-11-5，4:27
Hi @Eric
To generate a “.iq” file in binary format from IQ data in MATLAB, you need to follow these steps:
  1. Prepare Your IQ Data
  2. Open a File for Writing
  3. Write the Data
  4. Close the File
To open a file, write data to it, and then close it, you can utilise the “fopen”, “fwrite”, and “fclose” functions respectively.
Kindly refer to the following MATLAB script for understanding. (This script assumes you want to write the IQ data in a simple interleaved binary format.)
% Example IQ data
I = [0.1, 0.2, 0.3, 0.4]; % In-phase component
Q = [0.5, 0.6, 0.7, 0.8]; % Quadrature component
% Combine into complex format
IQ_data = I + 1i*Q;
% Open a file for binary writing
fileID = fopen('output.iq', 'wb');
% Check if the file opened successfully
if fileID == -1
error('Failed to open the file.');
end
% Write the IQ data to the file
% Here, we assume single precision (32-bit) for both I and Q components
fwrite(fileID, [real(IQ_data); imag(IQ_data)], 'float32');
% Close the file
fclose(fileID);
disp('IQ data has been written to output.iq');
The script uses “float32” to represent each I and Q component. Adjust the data type as needed (e.g., “float64” for double precision).
For more information about “fopen”, “fwrite” and “fclose” kindly refer following MathWorks Documentation.
fopen: https://www.mathworks.com/help/matlab/ref/fopen.html
fwrite: https://www.mathworks.com/help/matlab/ref/fwrite.html
fclose: https://www.mathworks.com/help/matlab/ref/fclose.html
I hope this will be helpful.
  1 个评论
Walter Roberson
Walter Roberson 2024-11-5，5:14
@Eric earlier asked a similar question but phrased it as being related to aaronia rtsa suite. That makes it more likely that the file format being referred to is the one described in the link I posted above. But it is certainly not clear which file format Eric requires.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Low-Level File I/O 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by