Trying to create a power factor correction system but no data shows

33 次查看（过去 30 天）
DeSean
DeSean 2024-11-18，17:55
编辑： Hitesh 2024-11-19，4:12
I've created a system. There's no errors listed, but the data inspector does not show any data and I'm unable to connect the circuit to a scope.
  6 个评论
显示 4更早的评论
Walter Roberson
Walter Roberson 2024-11-18，19:35
Your link to matlab.mathworks.com does not work.
At the time I was testing you had not yet posted the slx file.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Hitesh
Hitesh 2024-11-19，4:11
编辑：Hitesh 2024-11-19，4:12
Hi DeSean,
You need to use "PS-Simulink Converter" block which will convert the physical signal into Simulink output signal. Once done, you can connect it to the "scope" block, and the data will be displayed in the data inspector. I have revised " project.slx" file.
For more information on "PS-Simulink Converter", refer to the below MATAB documentation,
https://www.mathworks.com/help/simscape/ref/pssimulinkconverter.html

更多回答（1 个）

Walter Roberson
Walter Roberson 2024-11-18，19:47
You have Physical Signals. You need to convert them before Scope. https://www.mathworks.com/help/simscape/ref/pssimulinkconverter.html

类别

在 Help Center 和 File Exchange 中查找有关 View and Analyze Simulation Results 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by