how to set the default datatype of simulink block output to single

31 次查看（过去 30 天）
wenchao zhang
wenchao zhang 2024-12-14
编辑： Shuba Nandini 2024-12-17
how to set the default datatype of simulink block output to single, for example i just want the output datatype of signal builder set to signle, i do not want use data type convert to realize.
  2 个评论
Walter Roberson
Walter Roberson 2024-12-14
According to https://stackoverflow.com/questions/23337769/change-standard-data-type-simulink-matlab-function-block
"It could by possible by changing the parameter "Default for underspecified data type" (DefaultUnderspecifiedDataType) in the Optimization category inside the Configuration Parameters of your model to single.
I'm not sure if it affects MATLAB function blocks, though."

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Shuba Nandini
Shuba Nandini 2024-12-17
编辑：Shuba Nandini 2024-12-17
Hi,
I understand that you would like to set the default data type of the Signal Builder block to 'single.'
As of the Simulink R2018b release, the Signal Builder block only supports the 'double' data type. To work around this issue, you can place a Signal Conversion block at the output port of the Signal Builder block and configure its data type to 'single.'
Please refer to the following MATLAB documentation link to know more about Signal Conversion block:
https://www.mathworks.com/help/simulink/slref/signalconversion.html
Regards,
Shuba Nandini

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

产品


版本

R2018b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by